MARINE GRADE Premium Clear Wood Sealer

• Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C.
• Do not apply in rain or when rain is expected within 12-24 hours.
• DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
• Test a small area to ensure acceptable appearance and penetration.
• Apply first coat with a synthetic brush; pump-up garden sprayer; air-assisted; and/or airless sprayer. Use 15-17 tip and medium to coarse spray pattern. When spraying, always back brush for best results.
• Second coat can be applied once the first coat is damp. Second coat should be applied within 20-30 minutes after applying the first coat. Heat and humidity can decrease the time between coats. Non-Hazardous to aquatic life (GHS) when applied according to application instructions.
• For best results, apply in the shade and out of direct sunlight.
• When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply SEAL-ONCE® Marine Grade Clear Premium Wood Sealer
immediately on dampened surface.
• Do not use with other waterproofing products.
• If using as an end grain sealer remove the sealer from the ends and any access on the top, sides, or bottom of the surfaces before staining. Can be re-applied to the end grains after the stain has fully cured for added protection.

SEAL-ONCE® has been leading the innovation in the use of nanotechnology to create long-lasting, Eco-friendly wood sealers & tinted wood stains since 2005.   MARINE GRADE wood sealer and dock stain is specifically formulated to provide the highest level of protection for wood structures, situated near open water.  Wood used on boat docks, decks, and retaining walls near rivers, lakes, ponds or the ocean is subjected to near constant moisture.  MARINE provides the highest level of protection in those environments.  It is a great investment to extend the useful life of wood subjected to these harsh marine conditions, is non-hazardous to aquatic life.

SEAL-ONCE® MARINE Premium Waterproofing Wood Sealer & Stain is designed to protect & stabilize marine wood against water damage, salt water spray & decay.  Unlike many top-coat sealers on the market today, it penetrates wood below the surface, coating the wood fibers at the cellular level, which creates a long-lasting, flexible, breathable barrier.  It provides long-lasting protection from the inside out.

Clear formula allows wood to age naturally without decay, morphing to a rich silver-gray over time. Seal-Once Marine, when tinted as a wood stain, gives added protection from decay. Prevents long-standing water accumulation for up to 10 years on vertical & up to 6 years on horizontal surfaces.