NANO+POLY Concrete & Masonry Sealer
NANO+POLY Concrete & Masonry Sealer
NANO+POLY Concrete & Masonry Sealer combines proprietary nanotechnology with the strength of polyurethane to provide 360° of protection. NANO+POLY penetrates below the surface to protect against water damage from the inside-out.
GREAT FOR USE ON
GREAT FOR USE ON
- Brick/Masonry
- Bricks Pavers
- Concrete Patios
FEATURES
FEATURES
- Water-based, Ultra-Low VOC
- Eco-friendly, Non-toxic, No Odor
- Won't harm people, pets or plants
- Penetrates below the surface
- Creates flexible, breathable barrier
- Helps prevent freeze/thaw damage
- Prohibits cracking, spalling & mold
- Non-yellowing, Will not peel
- Easy soap & water clean-up
DATA SHEETS
DATA SHEETS
Collapsible content
APPLICATIONS
- Do not use if air or surface temperature is below 50°F/10°C or above 95°F/35°C.
- Do not apply in rain or when rain is expected within 24-48 hours
- DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
- Test a small area to ensure acceptable appearance and penetration.
- Apply first coat with a synthetic brush; pump-up garden sprayer; air-assisted; and/or airless sprayer. Use 15-17 tip and medium to coarse spray pattern. When spraying, always back brush for best results.
- Second coat can be applied once first coat has penetrated but is still damp. Second coat should be applied within one hour of applying first coat.
- Allow 3-4 hours for surface to dry completely before permitting light foot traffic.
- For best results, apply in the shade and out of direct sunlight.
- Apply to all surfaces.
- Do not use with other waterproofing products.
- Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in.
- For surface temperatures that are hot to the touch, dampen the surface to bring the temperature down prior to applying the first coat.
- When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply Nano Poly Concrete immediately on dampened surface.
PRODUCT DETAILS
- Allow approximately 3-4 hours for surface to dry, depending on temperature and humidity, before subjecting to light foot traffic.
- Allow 24-48 hours for full cure, depending on temperature and humidity.
- When recoating, apply once previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying the first coat.
- Clean all application equipment with warm soapy water.
- Disposal: soap and water cleanup; no special disposal procedure needed.
- Store above 32°F/0°C to protect from freezing.
- Shelf life (unopened): 2 years