1 6

Multi-Surface Concentrate Wood, Concrete & Masonry Sealer

Multi-Surface Concentrate Wood, Concrete & Masonry Sealer

Multi-Surface Concentrate with NANO deeply penetrates the surface to protect & stabilize wood, concrete & masonry against adverse weather & caustic conditions, including salt water spray. 

Size
Not Available

GREAT FOR USE ON

  • Stamped & Concrete Patios
  • Brick Pavers
  • Brick & Masonry
  • Wood Surfaces

FEATURES

  • Water-based, Ultra-Low VOC
  • Eco-friendly, Non-toxic, No Odor
  • Won't harm people, pets or plants
  • Penetrates below the surface
  • Creates flexible, breathable barrier
  • Helps resist mildew & wood rot
  • Stabilizes from cracking & spalling
  • Easy soap & water clean-up
  • Clear allows the wood to grey naturally

DATA SHEETS

View full details

APPLICATIONS

  • Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C.
  • Do not apply in rain or when rain is expected within 12-24 hours. For all stains (including Ready-Mixed), intermix gallons and stir to ensure color consistency.
  • DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
  • Test a small area to ensure acceptable appearance and penetration.
  • Apply first coat with a synthetic brush; pump-up garden sprayer; air-assisted; and/or airless sprayer. Use 15-17 tip and medium to coarse spray pattern. When spraying, always back brush for best results.
  • Second coat can be applied once first coat has penetrated but is still damp. Second coat must be applied within one hour of applying first coat.
  • For best results, apply in the shade and out of direct sunlight.
  • When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply Multi-Surface Concentrate immediately on dampened surface.
  • Apply to all surfaces. Apply SEAL ENDS ONCE® to wood ends.
  • Do not use with other waterproofing products.
  • Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in.
  • For surface temperatures that are hot to the touch, dampen the surface to bring the temperature down prior to applying the first coat.

PRODUCT DETAILS

  • Allow approximately 2-3 hours for surface to dry, depending on temperature and humidity.
  • Allow 12-24 hours for full cure, depending on temperature and humidity.
  • When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying the first coat.
  • Clean all application equipment with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.
  • Store above 32°F/0°C to protect from freezing.
  • Shelf life (unopened): 3 years