1 8

NANO Penetrating Wood Sealer

NANO Penetrating Wood Sealer

NANO Penetrating Wood Sealer deeply penetrates the surface of wood to protect and stabilize against water damage and decay.  Unlike many top-coat sealers that trap moisture below the surface, NANO creates a long-lasting, flexible, breathable barrier, that allows water vapor to escape & help prevent damage. 

The clear, non-film forming formula allows the wood to age naturally without decay, morphing to a rich silver-gray over time. It can also be used as a wood stain, when mixed with a full range of semi-transparent tints to enhance the appearance & provide additional protection from wood decay.

Size
Not Available

GREAT FOR USE ON

  • Fences
  • Wood Siding
  • Log Homes
  • Shake Roofs
  • Thermally Modified Wood
  • Outdoor Furniture
  • Swing Sets
  • Pergola
  • Shakes
  • Decks

FEATURES

  • Water-based, Ultra-Low VOC
  • Eco-friendly, Non-toxic, No Odor
  • Won't harm people, pets or plants
  • Penetrates below the surface
  • Creates flexible, breathable barrier
  • Helps resist mildew & wood rot
  • Stabilizes wood from warping
  • Extends natural life of wood
  • Easy soap & water clean-up
  • Clear allows the wood to grey naturally

DATA SHEETS

View full details

APPLICATIONS

  • Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C.
  • Do not apply in rain or when rain is expected within 12-24 hours. For all stains (including Ready-Mixed), intermix gallons and stir to ensure color consistency.
  • DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
  • Test a small area to ensure acceptable appearance and penetration.
  • Apply first coat with a synthetic brush; pump-up garden sprayer; air-assisted and/or airless sprayer. Use 15-17 tip and medium to coarse spray pattern. When spraying, always back brush for best results.
  • Second coat can be applied once first coat has penetrated but is still damp. Second coat must be applied within one hour of applying first coat.
  • For best results, apply in the shade and out of direct sunlight.
  • When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply SEAL-ONCE NANO immediately on dampened surface.
  • Apply to all surfaces. Apply SEAL ENDS ONCE® to wood ends.
  • Do not use with other waterproofing products.
  • Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in.

PRODUCT DETAILS

  • Allow approximately 2-3 hours for surface to dry, depending on temperature and humidity.
  • Allow 12-24 hours for full cure, depending on temperature and humidity.
  • When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying the first coat.
  • Clean all application with warm soapy water.
  • Disposal: soap and water cleanup; no special disposal procedure needed.
  • Store unused product above 32°F/0°C to protect from freezing.
  • Shelf life (unopened): 3 years