SEAL ENDS ONCE uses a proprietary nanotechnology to form a flexible, breathable barrier by coating the wood fibers at the cellular, unlike most wax end sealers that form a wax top-coat. SEAL ENDS ONCE is the best choice to seal the ends of your deck.
Do not use if air or surface temperature is below 45°F/7.22°C or above 95°F/35°C.
Do not apply in rain or when rain is imminent. For all stains (including Ready-Mixed), intermix gallons and stir to ensure color consistency.
DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
Test a small area to ensure acceptable appearance and penetration.
Apply first coat to end cuts using a synthetic brush or stain pad.
Second coat can be applied once first coat has penetrated but is still damp. Second coat must be applied within one hour of applying first coat.
For best results, apply in the shade and out of direct sunlight.
When applying in direct sunlight and wood surface is hot, spray with a mist of water and apply SEAL ENDS ONCE immediately on dampened surface.
Do not use with other waterproofing products.
Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in.
PRODUCT DETAILS
Allow approximately 2-3 hours, for surface to dry, depending on temperature and humidity.
Allow 12-24 hours for full cure, depending on temperature and humidity.
When recoating, apply as soon as previous coat has penetrated and surface is damp, not wet. Second coat must be applied within one hour of applying first coat.
Clean all application equipment with warm soapy water.
Disposal: soap and water cleanup; no special disposal procedure needed.
Store above 32°F/0°C to protect from freezing.
Shelf life (unopened): 3 years
Maintenance and Care
Surfaces that have been treated with SEAL ENDS ONCE can be cleaned using a mixture of 1 gallon warm water, 14 oz. bleach, and 1 oz. of Dawn® dish detergent. Apply this cleaning solution with a sprayer and allow to sit for 20 to 30 minutes on the wood surface before rinsing with water using a garden hose with a nozzle.
This cleaning solution can be used to remove airborne mildew stains, dirt and grime from the wood surface. SEAL ENDS ONCE will prevent and resist any water and mildew penetration. Do not use oxidizers, corrosives, or strippers on surfaces that have been treated with SEAL ENDS ONCE.
Surfaces can be recoated with SEAL ENDS ONCE at any time. SEAL ENDS ONCE may need to be reapplied in places where the surface may have undergone noticeable changes.
Before reapplying SEAL ENDS ONCE, clean the surface using the recommended cleaning solution above. Apply SEAL ENDS ONCE according to package instructions. When reapplying in small areas, lightly overlap onto areas previously treated with SEAL ENDS ONCE.
Choosing a selection results in a full page refresh.
